Bodyworx JX125 Owner's Manual download pdf (Page 10)

- 9 -

7. MAINTENANCE

1. If the belt tends to move off the center, stop the treadmill.

Take the Hex Wrench and adjust the Hex Screw in the Rear

End Cap. For example, if the running belt is moving towards

the left side, tighten the left Hex Screw about 1/4

turn(clockwise); if the running belt is moving towards the

right side, tighten the right Hex Screw about 1/4

turn(clockwise); Turn on the treadmill after it has been

adjusted. If you find that the belt has not moved to the proper

position, please repeat the steps above. Don’t use the treadmill

until the running belt returns to the center position.

(PS.1. This action is very important, if the belt is not in the

center, be sure to follow above steps.)

(PS.2. The position of running belt might not stay precisely in

the center with slightly towards the left and right sides,

and the situation varies with how end-users use and the

weight of end-users. No need to adjust the belt if it doesn’t

rub against the parts aside.)

2. Depending on the usage of the product, please apply

SILICON on the board according to the below chart. Use

the Hex Wrench to unscrew the bolt inside the Rear Roller.

Then pull the belt up and daub some SILICON to the center

of the board. After that, adjust the belt to the center of the

deck, followed by tightening the screw to the original set.

(PS.W hen the belt is sliding, please follow the above method

to lubricate the running belt. )

KGS/LBS Speed Interval

6KM/hr Below

6~12KM/hr

KGS

12KM/hr Above

4mile/hr Below

4~8mile/hr

LBS

8mile/hr Above

1 year

6 months

3 months

6 months

1 year

3 months

Note: This maintenance is intended for

household use.

If used for business, it is suggested to

examine the product every other month

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comments to this Manuals

No comments

Bodyworx JX125 Owner's Manual Page 10

Comments to this Manuals