Bodyworx JX125 Owner's Manual download pdf (Page 11)

7. MAINTENANCE

1. If the belt tends to move off the center, stop the treadmill.

Take the Hex Wrench and adjust the Hex Screw in the Rear

End Cap. For example, if the running belt is moving towards

the left side, tighten the left Hex Screw about 1/4

turn(clockwise); if the running belt is moving towards the

right side, tighten the right Hex Screw about 1/4

turn(clockwise); Turn on the treadmill after it has been

adjusted. If you find that the belt has not moved to the proper

un ion.

(Ps.

end-users use and the

position, please repeat the steps above. Don’t use the treadmill

til the running belt returns to the center posit

(Ps.1. This action is very important, if the belt is not in the

enter, be sure to follow above steps.)

2. The position of running belt might not stay precisely in

the center with slightly towards the left and right sides,

and the situation varies with how

weight of end-users. No need to adjust the belt if it doesn’t

rub against the parts aside.)

e screw to the original set.

(Ps. When the belt is sliding, please follow the above method

lubricate the running belt. )

2. Depending on the usage of the product, please apply

SILICON on the board according to the below chart. Use

the Hex Wrench to unscrew the bolt inside the Rear Roller.

Then pull the belt up and daub some SILICON to the center

of the board. After that, adjust the belt to the center of the

deck, followed by tightening th

GS/LBS Speed Interval

6KM/hr below

1 year

6~12KM/hr

6 months

KGS

1 2KM/hr above

3 months

4mile/hr below

1 year

4~8mile/hr

6 months

LBS

8mile/hr above

3 months

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 24 25

Comments to this Manuals

No comments

Bodyworx JX125 Owner's Manual Page 11

Comments to this Manuals

Related products and manuals for Treadmills Bodyworx JX125